| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014YO0 |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - ] |
| Title: LIGHTING (EXT): HEIGHT CONTROL SENSOR: INSPECTION; 2018 - 2024 MY Camry HV [07/2017 - ] | ||
INSPECTION
PROCEDURE
1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
(a) Preparation for check
(1) Confirm the standard, high and low positions of the link that will be used in the following inspection.
- The standard position is 58° from the maximum link angle (high) and 51° from the maximum link angle (low).
- The high position (+45°) is 13° from the maximum link angle (high).
- The low position (-45°) is 6° from the maximum link angle (low).
|
*a |
Standard Position |
*b |
Maximum Link Angle (Low) |
|
*c |
Maximum Link Angle (High) |
*d |
51° |
|
*e |
58° |
*f |
-45° |
|
*g |
+45° |
*h |
6° |
|
*i |
13° |
- |
- |
(2) Connect 3 dry cell batteries (1.5 V) in series.
NOTICE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
(3) Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).
|
*a |
Component without harness connected (Rear Height Control Sensor Sub-assembly LH) |
*b |
Low |
|
*c |
Standard Position |
*d |
High |
|
*e |
-45° |
*f |
+45° |
(4) Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
2 (SHRR) - 1 (SHG) |
+45° (High) |
4.5 V |
|
2 (SHRR) - 1 (SHG) |
0° (Standard position) |
2.5 V |
|
2 (SHRR) - 1 (SHG) |
-45° (Low) |
0.5 V |
If the result is not as specified, replace the rear height control sensor sub-assembly LH.
|
|