| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014YNQ |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - ] |
| Title: LIGHTING (EXT): AUTOMATIC HIGH BEAM MAIN SWITCH: INSPECTION; 2018 - 2024 MY Camry HV [07/2017 - ] | ||
INSPECTION
PROCEDURE
1. INSPECT AUTO HIGH BEAM SWITCH
|
*a |
Component without harness connected (Auto High Beam Switch) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
5 (+B) - 2 (E) |
Auto high beam switch not pressed |
10 kΩ or higher |
|
Auto high beam switch pressed |
Below 1 Ω |
If the result is not as specified, replace the auto high beam switch.
(b) Illumination Inspection
(1) Apply auxiliary battery voltage to the auto high beam switch and check that the switch illuminates.
OK:
|
Condition |
Specified Condition |
|---|---|
|
Auxiliary battery positive (+) → Terminal 6 (ILL+) Auxiliary battery negative (-) → Terminal 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the auto high beam switch.
(c) Indicator Inspection
(1) Apply auxiliary battery voltage to the auto high beam switch and check that the indicator illuminates.
OK:
|
Condition |
Specified Condition |
|---|---|
|
Auxiliary battery positive (+) → Terminal 3 (IND+) Auxiliary battery negative (-) → Terminal 4 (AZBI) |
Illuminates |
If the result is not as specified, replace the auto high beam switch.
|
|