| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014YMP |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - ] |
| Title: LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: REMOVAL; 2018 - 2024 MY Camry HV [07/2017 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE SPARE WHEEL COVER ASSEMBLY
Click here
![2018 - 2024 MY Camry HV [07/2017 - ]; DOOR / HATCH: LUGGAGE COMPARTMENT DOOR SUPPORT: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE SPARE WHEEL COVER TRAY
Click here
3. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
4. REMOVE LUGGAGE COMPARTMENT DOOR STRIKER COVER
Click here
5. REMOVE REAR FLOOR FINISH PLATE
Click here
6. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH (for RH Side)
Click here
7. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER LH (for LH Side)
Click here
8. REMOVE REAR COMBINATION LIGHT COVER
(a) Using a moulding remover, disengage the 3 claws as shown in the illustration.
|
Insert Moulding Remover Here |
|
Remove in this Direction |
(b) Disengage the 2 claws to remove the rear combination light cover as shown in the illustration.
|
|
Remove in this Direction |
9. REMOVE REAR COMBINATION LIGHT ASSEMBLY
|
(a) Disconnect the connector. |
|
(b) Apply protective tape around the rear combination light assembly as shown in the illustration.
|
Protective Tape |
|
(c) Remove the 2 screws. |
|
(d) Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.
NOTICE:
To prevent the rear combination light assembly from falling when disengaging the pin and guides, lightly hold the rear combination light assembly.
|
*a |
Pin |
|
*b |
Guide |
|
|
Remove in this Direction |
|
(e) Disengage the grommet to remove the rear combination light assembly. |
|
|
|