LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL; 2018 - 2020 MY Camry HV [07/2017

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM1000000014YME
Model Year Start: 2018	Model: Camry HV	Prod Date Range: [07/2017 - 10/2020]
Title: LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Front bumper assembly (w/ Panoramic view monitor system)

Front television camera view adjustment

Panoramic view monitor system

for Initialization

for Calibration

Headlight ECU sub-assembly LH
Headlight assembly LH

Synchronize the vehicle information
Perform headlight ECU sub-assembly LH initialization

Lighting system (w/ AFS)(EXT)

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

Click here

2. REMOVE HEADLIGHT ASSEMBLY

(a) Apply protective tape around the headlight assembly as shown in the illustration.

Protective Tape

(b) Remove the bolt and 3 screws.

*a	Bolt
*b	Screw

Remove in this Direction

(d) for Bulb Type Turn Signal Light:

(1) Disengage the clamp.

(e) w/o AFS:

(1) Disconnect each connector to remove the headlight assembly.

(f) w/ AFS:

(1) Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector to remove the headlight assembly.

*a	Connector Lock Lever
	Disconnect in this Direction