Power source mode does not change to on (IG) or on (ACC)
|
Smart key system (for Entry Function)
|
|
Wireless charging system*1
|
Affected by wave interference
|
Transmitter battery
|
Electrical key transmitter sub-assembly
|
No. 1 indoor electrical key antenna assembly (front floor)
|
No. 1 indoor electrical key antenna assembly (rear floor)
|
Power switch
|
Wire harness or connector
|
Instrument panel junction block assembly
|
Certification ECU (Smart key ECU assembly)
|
Power source mode does not change to on (IG)
|
Wire harness or connector
|
|
Relay
|
Instrument panel junction block assembly
|
Certification ECU (Smart key ECU assembly)
|
Power source mode does not change to on (ACC)
|
Wire harness or connector
|
|
Relay
|
Instrument panel junction block assembly
|
Certification ECU (Smart key ECU assembly)
|
Power source mode does not change to ON (READY)
|
Hybrid control system
|
|
Immobiliser function
|
Steering lock function
|
Wire harness or connector
|
Shift lock control unit assembly
|
Stop light switch assembly
|
Certification ECU (Smart key ECU assembly)
|
New key cannot be registered
|
LIN communication system
|
|
Meter / gauge system
|
Reregistration
|
Electrical key transmitter sub-assembly
|
Steering lock ECU (Steering lock actuator or upper bracket assembly)
|
Certification ECU (Smart key ECU assembly)
|
Additional key cannot be registered
|
Steering lock function
|
|
Electrical key transmitter sub-assembly
|
Certification ECU (Smart key ECU assembly)
|
New key registration warning message is not displayed
|
Lighting system (int)
|
|
Meter / gauge system
|
Certification ECU (Smart key ECU assembly)
|
Unable to unlock steering wheel (hybrid control system cannot start)
|
Wire harness or connector
|
|
Steering lock ECU (Steering lock actuator or upper bracket assembly)
|
Certification ECU (Smart key ECU assembly)
|
Steering lock does not lock
|
Lighting system (int)
|
|
Wire harness or connector
|
Steering lock ECU (Steering lock actuator or upper bracket assembly)
|
Certification ECU (Smart key ECU assembly)
|
Security indicator light does not blink
|
Wire harness or connector
|
|
Security indicator light (Telltale light assembly)
|
Main body ECU (Multiplex network body ECU)
|
Certification ECU (Smart key ECU assembly)
|
Immobiliser system does not operate properly
|
Communication ID registration was defective
|
|
Wire harness or connector
|
Hybrid vehicle control ECU assembly
|
Hybrid control system cannot be started by remote air conditioner with remote start (Both the wireless door lock control system and push-button start function operate normally)*2
|
Refer to "Remote Engine Starter does not Operate"
|
|