| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014XMM |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - ] |
| Title: HYBRID / BATTERY CONTROL: HV RELAY ASSEMBLY (for NICKEL METAL HYDRIDE BATTERY): INSTALLATION; 2018 - 2024 MY Camry HV [07/2017 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY
CAUTION:
Be sure to wear insulated gloves and protective goggles.
(a) Install the HV battery junction block assembly to the HV battery with the 4 nuts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
NOTICE:
If the HV battery junction block assembly has been struck or dropped, replace it with a new one.
(b) Connect the HV battery junction block assembly connector.
NOTICE:
Make sure that the connectors are connected securely.
(c) Engage the 2 claws to install the wiring harness protector.
(d) Connect the HV battery junction block assembly connector.
NOTICE:
Make sure that the connectors are connected securely.
(e) Engage the 2 claws to close the wiring harness protector.
(f) Engage the clamp.
(g) Connect the HV battery junction block assembly connector.
NOTICE:
Make sure that the connectors are connected securely.
(h) Connect the electric vehicle battery plug assembly with the bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
2. INSTALL UPPER HV BATTERY COVER SUB-ASSEMBLY
Click here
![2018 - 2024 MY Camry HV [07/2017 - ]; HYBRID / BATTERY CONTROL: BATTERY VOLTAGE SENSOR(for NICKEL METAL HYDRIDE BATTERY): INSTALLATION+](/t3Portal/stylegraphics/info.gif)
3. INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT
Click here
4. CONNECT FLOOR WIRE
CAUTION:
Be sure to wear insulated gloves.
(a) Engage the 2 clamps to connect the floor wire.
(b) Connect the HV battery junction block assembly connector.
(c) Connect the electric vehicle battery plug assembly connector.
(d) Engage the clamp.
5. CONNECT FLOOR UNDER WIRE
Click here
6. INSTALL NO. 1 HV BATTERY COVER PANEL RH
Click here
7. INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
Click here
8. INSTALL REAR UNDER COVER
Click here
9. INSTALL REAR UNDER SIDE COVER LH
Click here
10. INSTALL REAR DOOR SCUFF PLATE LH
Click here
11. INSTALL REAR UNDER SIDE COVER RH
Click here
12. INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
13. INSTALL NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
Click here
14. INSTALL SERVICE PLUG GRIP
Click here
|
|