Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000014WKH |
Model Year Start: 2018 |
Model: Camry HV |
Prod Date Range: [07/2017 - 10/2020] |
Title: THEFT DETERRENT / KEYLESS ENTRY: CERTIFICATION ECU: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during certification ECU (smart key ECU assembly) removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative (-) auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
Certification ECU (smart key ECU assembly)
|
Code registration (Smart key System (for Start Function)
|
-
Wireless door lock control system
-
Smart key system (for Entry Function)
-
Smart key system (for Start Function)
-
Steering lock function
|
|
*: When performing learning using the Techstream.
Click here
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
2. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Click here
3. REMOVE ECU INTEGRATION BOX RH
Click here
4. REMOVE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Using a screwdriver, disengage the 2 claws and remove the certification ECU (smart key ECU assembly) as shown in the illustration.
|
Remove in this Direction
|
|