| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014W6S |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - 10/2020] |
| Title: CRUISE CONTROL: FORWARD RECOGNITION CAMERA SYSTEM: C1AA9; Front Camera Module Beam Axis Not Adjusted; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] | ||
|
DTC |
C1AA9 |
Front Camera Module Beam Axis Not Adjusted |
DESCRIPTION
If forward recognition camera adjustment is not performed after installing the forward recognition camera, DTC C1AA9 is stored.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1AA9 |
Front Camera Module Beam Axis Not Adjusted |
After the power switch is turned on (IG) for 3 seconds or more, when the vehicle is being driven at a speed of 1 km/h or 1 mph or more, the forward recognition camera detects that forward recognition camera adjustment has not been completed for 5 seconds or more. |
|
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
-
If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.
Click here
![2018 - 2020 MY Camry HV [07/2017 - 10/2020]; CRUISE CONTROL: FRONT CAMERA: ADJUSTMENT (SEQUENTIAL RECOGNITION)](/t3Portal/stylegraphics/info.gif)
PROCEDURE
|
1. |
CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM) |
(a) Clear the DTCs.
Chassis > Front Recognition Camera > Clear DTCs
(b) Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
- Turn the power switch on (IG) and wait 3 seconds or more.
- Drive the vehicle at a speed of 1 km/h or 1 mph or more for 5 seconds or more.
(c) Check for DTCs.
Chassis > Front Recognition Camera > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTC C1AA9 is not output |
A |
|
DTC C1AA9 is output |
B |
| A |
|
END |
|
|
2. |
PERFORM FORWARD RECOGNITION CAMERA ADJUSTMENT |
(a) Perform forward recognition camera adjustment.
Click here
|
|
3. |
CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM) |
(a) Clear the DTCs.
Chassis > Front Recognition Camera > Clear DTCs
(b) Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
- Turn the power switch on (IG) and wait 3 seconds or more.
- Drive the vehicle at a speed of 1 km/h or 1 mph or more for 5 seconds or more.
(c) Check for DTCs.
Chassis > Front Recognition Camera > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTC C1AA9 is not output |
A |
|
DTC C1AA9 is output |
B |
| A |
|
END |
| B |
|
|
|