| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014W6A |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - 10/2020] |
| Title: CRUISE CONTROL: FORWARD RECOGNITION CAMERA SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] | ||
|
HOW TO PROCEED WITH TROUBLESHOOTING |
CAUTION / NOTICE / HINT
HINT:
- Use the following procedure to troubleshoot the forward recognition camera system.
- *: Use the Techstream.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
INSPECT AUXILIARY BATTERY VOLTAGE |
(a) Measure the auxiliary battery voltage with the power switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.
|
|
3. |
CHECK CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check if the CAN communication system is functioning normally.
HINT:
Refer to Communication Bus Check in CAN Communication System.
Click here
![2018 MY Camry HV [07/2017 - 09/2018]; NETWORKING: CAN COMMUNICATION SYSTEM: DIAGNOSIS SYSTEM](/t3Portal/stylegraphics/info.gif)
OK:
CAN communication system is functioning normally.
| NG |
|
|
|
4. |
CHECK FOR DTCs* (FORWARD RECOGNITION CAMERA SYSTEM) |
HINT:
Refer to DTC Check / Clear.
Click here
(a) Check for DTCs and note any codes that are output.
Chassis > Front Recognition Camera > Trouble Codes
(b) Clear the DTCs.
Chassis > Front Recognition Camera > Clear DTCs
(c) Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.
Chassis > Front Recognition Camera > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTCs are not output |
A |
|
DTCs are output |
B |
| B |
|
GO TO DTC CHART
|
|
|
5. |
PROBLEM SYMPTOMS TABLE |
HINT:
Refer to Problem Symptoms Table.
Click here
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table |
A |
|
Fault is listed in Problem Symptoms Table |
B |
| B |
|
|
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU
Click here
(b) Data List / Active Test
Click here
|
|
7. |
ADJUST, REPAIR OR REPLACE |
NOTICE:
If the forward recognition camera has been replaced with a new one, it is necessary to perform forward recognition camera adjustment.
Click here
|
|
8. |
CONFIRMATION TEST |
| NEXT |
|
END |
|
|