Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000014W31
Model Year Start: 2018 Model: Camry HV Prod Date Range: [07/2017 - 10/2020]
Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION; 2018 - 2020 MY Camry HV [07/2017 - 10/2020]

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

    Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: ADJUSTMENT

  • When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.

    Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM: CALIBRATION

PROCEDURE

1. INSTALL FRONT BUMPER ASSEMBLY

(a) Move the front bumper assembly into position and engage the 2 guides and 2 claws as shown in the illustration.

Install in this Direction

(b) Install the 4 bolts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

(c) Install the 2 clips.

(d) w/ Intuitive Parking Assist System:

(1) Connect the connector.

(e) w/ Panoramic View Monitor System:

(1) Connect the connector.

(f) Connect the connector.

(g) Engage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.

Install in this Direction

(h) Install the 8 screws.

(i) Install the clip.

HINT:

Use the same procedure for the RH side and LH side.

(j) Engage the 4 claws to install the 2 pin hold clips as shown in the illustration.

Install in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(k) Install the front bumper assembly.

2. INSTALL COOL AIR INTAKE DUCT SEAL

(a) Engage the guide as shown in the illustration.

Install in this Direction (1)

Install in this Direction (2)

(b) Install the cool air intake duct seal with the 5 clips.

3. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

4. ADJUST HEADLIGHT AIMING

HINT:

Perform this procedure only when replacement of the front bumper reinforcement is necessary.

Click here 2018 - 2024 MY Camry HV [07/2017 -        ]; LIGHTING (EXT): HEADLIGHT ASSEMBLY: ADJUSTMENT