Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000014W2Y
Model Year Start: 2018 Model: Camry HV Prod Date Range: [07/2017 - 10/2020]
Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Front bumper assembly (w/ Panoramic view monitor system)

Front television camera view adjustment

Panoramic view monitor system

2018 - 2020 MY Camry HV [07/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION for Initialization

2018 - 2020 MY Camry HV [07/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION for Calibration

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radarsensor adjustment.

Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: ADJUSTMENT

PROCEDURE

1. REMOVE COOL AIR INTAKE DUCT SEAL

(a) Remove the 5 clips.

(b) Disengage the guide and remove the cool air intake duct seal as shown in the illustration.

Remove in this Direction (1)

Remove in this Direction (2)

2. REMOVE FRONT BUMPER ASSEMBLY

(a) Apply protective tape around the front bumper assembly as shown in the illustration.

Protective Tape

(b) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration.

*a

Protective Tape

Insert Screwdriver Here

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(c) Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.

(d) Remove the 8 screws.

(e) Disengage the 3 claws as shown in the illustration.

Place Hand Here

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(f) Disconnect the connector.

*A

w/ Panoramic View Monitor System

*B

w/ Intuitive Parking Assist System

(g) w/ Panoramic View Monitor System:

(1) Disconnect the connector.

(h) w/ Intuitive Parking Assist System:

(1) Disconnect the connector.

(i) Remove the 2 clips.

(j) Remove the 4 bolts.

(k) Disengage the 2 claws and 2 guides to remove the front bumper assembly as shown in the illustration.

Remove in this Direction