HEATING / AIR CONDITIONING: BLOWER UNIT: REMOVAL; 2018 MY Camry HV [07/2017

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM1000000014V2X
Model Year Start: 2018	Model: Camry HV	Prod Date Range: [07/2017 - 09/2018]
Title: HEATING / AIR CONDITIONING: BLOWER UNIT: REMOVAL; 2018 MY Camry HV [07/2017 - 09/2018]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
*: When performing learning using the Techstream. Click here
Disconnect cable from negative auxiliary battery terminal	Perform steering sensor zero point calibration	Lane departure alert system (w/ Steering Control)
		Pre-collision system
		Intelligent clearance sonar system*
		Lighting system (w/ AFS)(EXT)
	Memorize steering angle neutral point	Parking assist monitor system
	Memorize steering angle neutral point	Panoramic view monitor system
Steering sensor	Steering angle neutral point (Initialize parking assist monitor system) Steering angle setting	Parking assist monitor system	for Initialization for Calibration

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

HINT:

Before removing the blower assembly, set the air conditioning to recirculation mode.

PROCEDURE

1. REMOVE AIR CONDITIONER UNIT ASSEMBLY

Click here

2. REMOVE NO. 2 INSTRUMENT PANEL WIRE

Click here

3. REMOVE NO. 2 AIR DUCT

Click here

4. REMOVE BLOWER ASSEMBLY

(a) Disconnect the connector.

(b) Disengage each guide.

(d) Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.