Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000014TYA |
Model Year Start: 2018 |
Model: Camry HV |
Prod Date Range: [07/2017 - 10/2020] |
Title: EXTERIOR PANELS / TRIM: GRILLE SHUTTER: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Front bumper assembly (w/ Panoramic view monitor system)
|
Front television camera view adjustment
|
Panoramic view monitor system
|
for Initialization
for Calibration
|
-
Swing grill actuator assembly
-
Radiator shutter sub-assembly
|
Change grille shutter control mode and/or perform initialization
|
Grille Shutter system
|
|
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here
2. REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH
(a) Disengage the 2 claws to remove the front radiator side air guide plate RH.
|
|
3. REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH
(a) Disengage the 2 claws to remove the front radiator side air guide plate LH.
|
|
4. REMOVE THERMISTOR ASSEMBLY
Click here
5. REMOVE RADIATOR SHUTTER SUB-ASSEMBLY
(a) Disconnect the connector.
|
|
(b) Disengage the clamp.
(c) Remove the 3 bolts.
(d) Disengage the 2 guides to remove the radiator shutter sub-assembly as shown in the illustration.
|
Remove in this Direction
|
|