Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001XWJB
Model Year Start: 2022 Model: Camry Prod Date Range: [08/2021 -           ]
Title: POWER OUTLETS (INT): WIRELESS CHARGING SYSTEM: Wireless Charger Illumination Circuit; 2022 - 2024 MY Camry [08/2021 -        ]

Wireless Charger Illumination Circuit

DESCRIPTION

When the light control switch is turned to the tail or head position, this circuit sends an illumination signal to the mobile wireless charger cradle assembly (front console box insert sub-assembly).

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

(a) Disconnect the k1 mobile wireless charger cradle assembly (front console box insert sub-assembly) connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

k2-7 (TAIL) - Body ground

Light control switch in off position

Below 1 V

Engine switch off, light control switch in tail or head position

11 to 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (FRONT CONSOLE BOX INSERT SUB-ASSEMBLY))

(a) Disconnect the K21 combination meter assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

K21-1 (ILL-) - k2-2 (ILL-)

Always

Below 1 Ω

K21-1 (ILL-) or k2-2 (ILL-) - Body ground

Always

10 kΩ or higher

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR