| Last Modified: 09-09-2025 | 6.11:8.1.0 | Doc ID: RM100000001XWJ9 |
| Model Year Start: 2022 | Model: Camry | Prod Date Range: [08/2021 - ] |
| Title: POWER OUTLETS (INT): WIRELESS CHARGING SYSTEM: Wireless Charger Power Source Circuit; 2022 - 2024 MY Camry [08/2021 - ] | ||
|
Wireless Charger Power Source Circuit |
DESCRIPTION
This is the power source circuit for the mobile wireless charger cradle assembly (front console box insert sub-assembly).
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (FRONT CONSOLE BOX INSERT SUB-ASSEMBLY) POWER SOURCE) |
(a) Disconnect the k2 mobile wireless charger cradle assembly (front console box insert sub-assembly) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
k2-1 (PGND) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
k2-4 (B+) - Body ground |
Always |
11 to 14 V |
|
k2-3 (ACC) - Body ground |
Engine switch on (ACC) |
11 to 14 V |
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|