| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001V49K |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C2A5D; BSM Buzzer Malfunction; 2021 - 2024 MY Camry [10/2020 - ] | ||
|
DTC |
C2A5D |
BSM Buzzer Malfunction |
DESCRIPTION
This DTC is stored when the rear television camera assembly receives an RCTA buzzer circuit malfunction signal from the blind spot monitor sensor RH.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C2A5D |
BSM Buzzer Malfunction |
The RCTA buzzer circuit is abnormal. |
Blind spot monitor system |
Parking Assist Camera |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
![2021 - 2024 MY Camry [10/2020 - ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (BLIND SPOT MONITOR SENSOR LH STATUS) |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Blind Spot Monitor Slave / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Blind Spot Monitor Slave > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Slave Side RCTA Function |
Switches the RCTA function on and off |
OFF or ON |
OFF: RCTA function off ON: RCTA function on |
- |
Body Electrical > Blind Spot Monitor Slave > Data List
|
Tester Display |
|---|
|
Slave Side RCTA Function |
|
Result |
Proceed to |
|---|---|
|
"Valid" and "ON" is displayed for all items. |
A |
|
"Invalid" or "OFF" is displayed. |
B |
| B |
|
|
|
2. |
CHECK DTC OUTPUT |
(a) Clear the DTCs.
Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Parking Assist Camera > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTC C2A5D is output |
A |
|
DTC C2A5D is not output |
B |
| B |
|
|
|
3. |
CHECK DTC OUTPUT (BLIND SPOT MONITOR SYSTEM (C1ABE)) |
(a) Check for DTCs.
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTC C1ABE is output |
A |
|
DTC C1ABE is not output |
B |
| A |
|
| B |
|
|
|