NOTICE:

• After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.
• When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

  System Name	See Procedure
  Lane Tracing Assist System
  Pre-collision System
  Parking Assist Monitor System
  Panoramic View Monitor System

NOTICE:

• When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
  • A communication malfunction DTC may be stored.
  • The radio and display receiver assembly or navigation ECU may not operate normally.
• When performing the following work, the navigation system may restart when turning the engine switch on (ACC) (due to radio and display receiver assembly and navigation ECU certification).
  • Repair or replace the negative (-) battery terminal due to it being disconnected or depleted.
  • The radio and display receiver assembly or navigation ECU replacement or removal and installation.
• When replacing the DCM (telematics transceiver), make sure to replace it with a new one (w/ Manual (SOS) Switch).
• After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.
• After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.