| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001U4Z6 |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: PRECAUTION; 2021 - 2024 MY Camry [10/2020 - ] | ||
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.
System Name
See Procedure
Lane Tracing Assist System
![2021 - 2022 MY Camry [10/2020 - 08/2022]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
Pre-collision System
Parking Assist Monitor System
Panoramic View Monitor System
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK |
Off (Lock) |
|
Ignition Switch ACC |
ACC |
On (ACC) |
|
Ignition Switch ON |
ON |
On (IG) |
|
Engine Start |
START |
On (Start) |
NOTICE:
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
- When replacing the DCM (telematics transceiver), be sure to replace it with a new one (w/ Manual (SOS) Switch).
PRECAUTION FOR AUDIO AND VISUAL SYSTEM
(a) If any of the following parts are replaced, refer to Initialization in Repair Instruction.
Click here
- Radio and display receiver assembly*1
- DCM (telematics transceiver)*2
-
*1: After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, SiriusXM radio ID registration is necessary (w/ SXM Function).
*2: w/ Manual (SOS) Switch
|
|