Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001TCVK
Model Year Start: 2021 Model: Camry Prod Date Range: [10/2020 -           ]
Title: EXTERIOR PANELS / TRIM: REAR BUMPER: REMOVAL; 2021 - 2024 MY Camry [10/2020 -        ]

REMOVAL

CAUTION / NOTICE / HINT

HINT:

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click here 2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT COVER LH

Click here 2018 - 2024 MY Camry [03/2017 -        ]; LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: REMOVAL+

2. REMOVE REAR COMBINATION LIGHT COVER RH

HINT:

Use the same procedure as for the LH side.

3. REMOVE REAR BUMPER ASSEMBLY

(a) Apply protective tape around the rear bumper assembly as shown in the illustration.

Protective Tape

(b) Remove the 2 screws.

(c) Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.

(d) for Single Type:

(1) Remove the 9 clips.

(e) for Dual Type:

(1) Remove the 8 clips.

(f) Disengage the 6 claws as shown in the illustration.

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(g) Disengage the 4 claws and 2 guides to remove the rear bumper assembly as shown in the illustration.

Remove in this Direction

(h) w/ Intuitive Parking Assist System:

(1) Disconnect the connector to remove the rear bumper assembly.