| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001TCQ2 |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: PARKING BRAKE: PARKING BRAKE SWITCH: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during parking brake switch assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here
|
|||
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision system |
|||
|
Parking Support Brake System*1 |
|||
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
|
Panoramic view monitor system |
|
||
PROCEDURE
1. SEPARATE PARKING BRAKE PEDAL ASSEMBLY
Click here
![2021 - 2024 MY Camry [10/2020 - ]; PARKING BRAKE: PARKING BRAKE PEDAL: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE PARKING BRAKE SWITCH ASSEMBLY
|
(a) Remove the screw and parking brake switch assembly from the parking brake pedal assembly. |
|
|
|