| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001TCPZ |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: PARKING BRAKE: PARKING BRAKE PEDAL: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during parking brake pedal assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here
|
|||
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision system |
|||
|
Parking Support Brake System*1 |
|||
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
|
Panoramic view monitor system |
|
||
PROCEDURE
1. LOOSEN NO. 1 WIRE ADJUSTING NUT
|
(a) Loosen the No. 1 wire adjusting nut. NOTICE: If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one. |
|
2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
![2021 - 2024 MY Camry [10/2020 - ]; SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): REMOVAL](/t3Portal/stylegraphics/info.gif)
3. REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
Click here
4. REMOVE INSTRUMENT PANEL TO PEDAL BRACKET
|
(a) Remove the bolt and nut. |
|
(b) Disengage the guide to remove the instrument panel to pedal bracket.
5. SEPARATE PARKING BRAKE PEDAL ASSEMBLY
|
(a) Disengage the clamp. |
|
(b) Disconnect the parking brake switch connector.
|
(c) Remove the 2 nuts, and separate the parking brake pedal assembly from the vehicle body. |
|
6. REMOVE PARKING BRAKE PEDAL ASSEMBLY
|
(a) Pull up the parking brake pedal assembly claw. NOTICE: Do not damage the No. 1 parking brake cable assembly. |
|
|
(b) Remove the No. 1 wire adjusting nut from the No. 1 parking brake cable assembly. NOTICE: If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one. |
|
|
(c) Remove the clip from the No. 1 parking brake cable assembly. |
|
(d) Remove the parking brake pedal assembly from the No. 1 parking brake cable assembly.
|
|