LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL; 2021 - 2024 MY Camry [10/2020

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM100000001T7I9
Model Year Start: 2021	Model: Camry	Prod Date Range: [10/2020 - ]
Title: LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

*1: Applies only for when removing and installing or replacing the rear television camera assembly.

Front bumper assembly (w/ Panoramic view monitor system)

Front television camera view adjustment

Panoramic view monitor system

for Initialization

for Calibration

Replacement or removal and installation of 2 or more parts:

Front television camera assembly, front bumper assembly or radiator grille
Rear television camera assembly
Side television camera assembly LH or outer rear view mirror assembly LH
Side television camera assembly RH or outer rear view mirror assembly RH

Television camera view adjustment
Rear television camera assembly optical axis (Back camera detection function)*1

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

Click here

2. REMOVE HEADLIGHT ASSEMBLY

(a) Apply protective tape around the headlight assembly as shown in the illustration.

Protective Tape

(b) Remove the bolt and 3 screws.

*a	Bolt
*b	Screw

Remove in this Direction

(d) for Bulb Type Turn Signal Light:

(1) Disengage the clamp.

(e) Disconnect each connector to remove the headlight assembly.