Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001T5F7
Model Year Start: 2021 Model: Camry Prod Date Range: [10/2020 -           ]
Title: DOOR LOCK: FRONT DOOR LOCK: REMOVAL; 2021 - 2024 MY Camry [10/2020 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front door lock with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Disconnect cable from negative battery terminal

Perform steering sensor zero point calibration

Lane Tracing Assist System

2021 - 2024 MY Camry [10/2020 -        ]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision system

Memorize steering angle neutral point

Parking assist monitor system

2018 - 2024 MY Camry [03/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION

Panoramic view monitor system

2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION

  • Front door glass sub-assembly
  • Front door glass run

Initialize power window control system

  • Auto up and down function
  • Jam protection function
  • Remote control function
  • Key-linked function
  • Wireless transmitter-linked function
  • Key-off operation function
  • Catch protection function
  • Window open warning function

2018 - 2024 MY Camry [03/2017 -        ]; WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: INITIALIZATION

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2020 - 2024 MY Camry [03/2020 -        ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

for A25A-FKS:

Click here 2021 - 2024 MY Camry [10/2020 -        ]; MAINTENANCE: A25A-FKS BATTERY: REMOVAL+

for 2GR-FKS:

Click here 2021 - 2024 MY Camry [10/2020 -        ]; MAINTENANCE: 2GR-FKS BATTERY: REMOVAL+

3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

4. REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

7. REMOVE FRONT ARMREST ASSEMBLY

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

8. REMOVE FRONT DOOR TRIM PLATE (w/o Courtesy Light)

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

9. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Click here 2018 - 2024 MY Camry [03/2017 -        ]; LIGHTING (INT): DOOR COURTESY LIGHT: REMOVAL+

10. REMOVE COURTESY LIGHT ASSEMBLY

Click here 2018 - 2024 MY Camry [03/2017 -        ]; LIGHTING (INT): DOOR COURTESY LIGHT: REMOVAL+

11. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

12. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

13. REMOVE FRONT DOOR SERVICE HOLE COVER

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

14. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

15. REMOVE FRONT DOOR PANEL PROTECTOR

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

16. REMOVE FRONT DOOR GLASS RUN

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

17. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

18. REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

19. REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

Click here 2021 - 2024 MY Camry [10/2020 -        ]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+

20. REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY

(a) Disconnect the connector.

*1

Front Door Lock Open Rod

Remove in this Direction

(b) Using a T30 "TORX" socket wrench, remove the 3 screws.

(c) Slide the front door lock with motor assembly downward to disconnect the front door lock open rod and remove the front door lock with motor assembly and cables as a unit.

(d) When reusing the front door lock with motor assembly:

(1) Remove the door lock wiring harness seal from the front door lock with motor assembly.

21. REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY

(a) Using a screwdriver, disengage the 2 claws as shown in the illustration.

(b) Disengage the 2 claws to remove the front door lock cover sub-assembly as shown in the illustration.

Remove in this Direction

22. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

(a) Remove the front door lock remote control cable assembly as shown in the illustration.

Remove in this Direction

23. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

(a) Remove the front door inside locking cable assembly as shown in the illustration.

Remove in this Direction