Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001T51B |
Model Year Start: 2021 |
Model: Camry |
Prod Date Range: [10/2020 -
] |
Title: STEERING COLUMN: STEERING WHEEL: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering wheel assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane tracing assist system
|
|
Pre-collision system
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
NOTICE:
-
Do not remove/install the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
-
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the ignition switch ON.
-
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
PROCEDURE
1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
2. REMOVE HORN BUTTON ASSEMBLY
Click here
3. REMOVE STEERING WHEEL ASSEMBLY
(a) Disconnect each connector.
(b) Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.
|
|
(c) Put matchmarks on the steering wheel assembly and steering main shaft.
|
|
(d) Temporarily install the steering wheel assembly set bolt.
NOTICE:
Do not overtighten the steering wheel assembly set bolt.
(e) Using SST, separate the steering wheel assembly.
SST: 09950-50013
09951-05010
09952-05010
09953-05020
09954-05031
09957-04010
SST: 09950-60010
09951-00330
NOTICE:
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
|
|
(f) Remove the steering wheel assembly set bolt and steering wheel assembly.
4. REMOVE STEERING PAD SWITCH ASSEMBLY
Click here
5. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)
for UB80E: Click here
for UB80F: Click here
for UA80E: Click here
6. REMOVE NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)
for UB80E: Click here
for UB80F: Click here
for UA80E: Click here
|