Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001T3WA
Model Year Start: 2021 Model: Camry Prod Date Range: [10/2020 -           ]
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: REMOVAL; 2021 - 2024 MY Camry [10/2020 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Blind spot monitor sensor

Blind spot monitor beam axis adjustment

  • Parking Support Brake System
  • Blind Spot Monitor System

2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK

Rear bumper assembly (w/ Parking Support Brake System)

  • Measurement of ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Parking Support Brake System
  • Intuitive Parking Assist System

2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: PARKING SUPPORT BRAKE SYSTEM: CALIBRATION

PROCEDURE

1. REMOVE REAR BUMPER ASSEMBLY

Click here 2021 - 2024 MY Camry [10/2020 -        ]; EXTERIOR PANELS / TRIM: REAR BUMPER: REMOVAL

2. REMOVE BLIND SPOT MONITOR SENSOR LH

(a) Disconnect the connector.

(b) Remove the 3 nuts and blind spot monitor sensor LH.

NOTICE:

Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.

3. REMOVE BLIND SPOT MONITOR SENSOR RH

(a) Disconnect the connector.

(b) Remove the 3 nuts and blind spot monitor sensor RH.

NOTICE:

Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.