- Replacement of fuel injector assembly (for Port Injection)
- Replacement of fuel injector assembly (for Direct Injection)
- Replacement of throttle body with motor assembly
- Cleaning the deposits from the throttle body with motor assembly
- Replacement of knock control sensor
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001T3V6 |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: 2GR-FKS (ENGINE CONTROL): KNOCK SENSOR: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision System |
|||
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
|
Panoramic View Monitor System |
|
||
|
|
Inspection after repair |
|
|
PROCEDURE
1. REMOVE FUEL DELIVERY PIPE
Click here
![2021 - 2024 MY Camry [10/2020 - ]; 2GR-FKS (FUEL): FUEL INJECTOR (for Direct Injection): REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE KNOCK CONTROL SENSOR
|
(a) Disconnect the 2 knock control sensor connectors. |
|
(b) Remove the 2 bolts and 2 knock control sensors from the cylinder block sub-assembly.
NOTICE:
If a knock control sensor has been struck or dropped, replace it.
|
|