Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001T3H4 |
Model Year Start: 2021 |
Model: Camry |
Prod Date Range: [10/2020 -
] |
Title: A25A-FKS (COOLING): WATER PUMP: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly (water inlet housing) removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision system
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
NOTICE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
PROCEDURE
1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Click here
2. REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
(a) Disconnect the sensor wire connector.
|
|
(b) Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).
|
|
(c) Disconnect the engine water pump assembly (water inlet housing) connector.
|
|
(d) Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.
|
|
(e) Remove the gasket from the engine water pump assembly (water inlet housing).
|
|
|