Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001SH67
Model Year Start: 2021 Model: Camry Prod Date Range: [10/2020 -           ]
Title: CRUISE CONTROL: FRONT CAMERA SYSTEM: DATA LIST / ACTIVE TEST; 2021 - 2024 MY Camry [10/2020 -        ]

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Read the Data List according to the display on the Techstream.

Chassis > Front Recognition Camera > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Total Distance Traveled

-

-

-

Cannot be used

Total Distance Traveled - Unit

-

-

-

Cannot be used

VGRS ECU Equipped Information

Variable gear ratio steering system function availability

Absence or Presence

Absence: Variable gear ratio steering system absence

Presence: Variable gear ratio steering system presence

If a display different from vehicle specification is output, a forward recognition camera that was used with a different vehicle was installed, or the forward recognition camera may be malfunctioning.

DRS System Equipped Information

Dynamic rear steering system function availability

Absence or Presence

Absence: Dynamic rear steering system absence

Presence: Dynamic rear steering system presence

If a display different from vehicle specification is output, a forward recognition camera that was used with a different vehicle was installed, or the forward recognition camera may be malfunctioning.

Vehicle Information (Steering Wheel Position)

Vehicle information (steering wheel installation location) stored by forward recognition camera

Unknown, Left or Right

Steering wheel installation location

If a display different from vehicle specification is output, a forward recognition camera that was used with a different vehicle was installed, or the forward recognition camera may be malfunctioning.

HV/EV Equipped Information

Vehicle information (engine) stored by forward recognition camera

Non-HV/EV or HV/EV

Non-HV/EV: Gasoline Model

HV/EV: HV Model

If a display different from vehicle specification is output, a forward recognition camera that was used with a different vehicle was installed, or the forward recognition camera may be malfunctioning.

Steering Vibrator Equipped Information

Whether steering vibration is installed or not

Absent / Present

Absent: Not equipped

Present: Equipped

If a display different from vehicle specification is output, a forward recognition camera that was used with a different vehicle was installed, or the forward recognition camera may be malfunctioning.

Buzzer (Line) Equipped Information

Whether or not a buzzer is installed to the forward recognition camera connected by direct line

Absent / Present

Absent: Not equipped

Present: Equipped

If a display different from vehicle specification is output, a forward recognition camera that was used with a different vehicle was installed, or the forward recognition camera may be malfunctioning.

Online Calibration Angle (Horizontal)

-

-

-

Cannot be used

Online Calibration Angle (Vertical)

-

-

-

Cannot be used

Online Calibration Angle (Roll Angle)

-

-

-

Cannot be used

Front Recognition Camera Axis Adjusted Status

-

-

-

Cannot be used

Front Recognition Camera Low Temperature

Whether low temperature malfunction of forward recognition camera exists or not

Not High Temperature or High Temperature

Not Low Temperature: Approximately -30°C (-22°F) or higher

Low Temperature: Approximately -30°C (-22°F) or less

  • If this item is "Low Temperature", it will display that the camera is temporarily unavailable.
  • If this item is "Low Temperature", X2016 is output in the vehicle control history.

Front Recognition Camera High Temperature 1

Whether high temperature malfunction of forward recognition camera exists or not

Not High Temperature or High Temperature

Not High Temperature: Approximately 80°C (176°F) or less

High Temperature: Approximately 80°C (176°F) or higher

  • If this item is "High Temperature", the camera will be temporarily unavailable. If this does not improve even if the inside of the vehicle is left cooled for at least 10 minutes, the forward recognition camera may be malfunctioning.
  • If this item is "High Temperature", X2016 is output in the vehicle control history.

HINT:

In summertime, the windshield glass may reach 100°C (212°F) or higher

Front Recognition Camera High Temperature 2

Whether high temperature malfunction of forward recognition camera exists or not

Not High Temperature or High Temperature

Not High Temperature: Approximately 65°C (149°F) or less

High Temperature: Approximately 65°C (149°F) or higher

If this item is "High Temperature", the automatic high beam system will be temporarily unavailable. If this does not improve even if the inside of the vehicle is left cooled for at least 10 minutes, the forward recognition camera may be malfunctioning.

HINT:

In summertime, the windshield glass may reach 100°C (212°F) or higher

Online Axis Alignment Error Code 31

Indicates whether online axis alignment error code 31 is present

Not Detected / Detected

Not Detected: error code not detected

Detected: error code 31 is detected

If this item is "Detected", it can be inferred that the vehicle speed at the start of online axis alignment was in excess of 5 km/h (3 mph), and online axis adjustment did not start.

Online Axis Alignment Error Code 32

Indicates whether online axis alignment error code 32 is present

Not Detected / Detected

Not Detected: error code not detected

Detected: error code 32 is detected

If this item is "Detected", it can be inferred that during online axis alignment, the field of view of the forward recognition camera was obstructed, causing online axis alignment to fail.

Online Axis Alignment Error Code 33

Indicates whether online axis alignment error code 33 is present

Not Detected / Detected

Not Detected: error code not detected

Detected: error code 33 is detected

If this item is "Detected", it can be inferred that during online axis alignment, DTCs or vehicle control history (RoB) occurred, causing online axis alignment to fail.

Online Axis Alignment Error Code 34

Indicates whether online axis alignment error code 34 is present

Not Detected / Detected

Not Detected: error code not detected

Detected: error code 34 is detected

If this item is "Detected", it can be inferred that the FOE value calculated via online axis alignment exceeded the normal range, causing online axis alignment to fail.

Online Axis Alignment Error Code 35

Indicates whether online axis alignment error code 35 is present

Not Detected / Detected

Not Detected: error code not detected

Detected: error code 35 is detected

If this item is "Detected", it can be inferred that the FOE value calculated via online axis alignment could not be correctly written to memory.

Heater Available Information

Whether a hot-wire heater exists in the forward recognition camera or not

Absence or Presence

Absence: w/o Heater Wire Heater

Presence: w/ Heater Wire Heater

The forward recognition camera checks conductivity with the hot-wire heater. If this item is "Absence", a new forward recognition camera may have been installed with the hot-wire heater disconnected.

Heater Control Permit

The control permission status of the hot-wire heater in the forward recognition camera

Not Allow or Allow

Not Allow: Hot-wire heater control not permitted

Allow: Hot-wire heater control permitted

If this item is "Not Allow", the following statuses are likely.

  • The forward recognition camera has stored vehicle control history
  • The air conditioning system is malfunctioning
  • Communication between the forward recognition camera and air conditioning amplifier assembly is lost

Heater Control

The control status of the hot-wire heater in the forward recognition camera

Not Control or Under Control

Not Control: Hot-wire heater not controlled

Under Control: Hot-wire heater controlled

If the hot-wire heater control permission item is "Allow" and the outside temperature is 10°C (50°F) or less, this item will repeatedly switch between "Not Control" and "Under Control". (For vehicles with whole surface deicers, this item will remain "No Control" when the whole surface deicer is in use.)