Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001SB40
Model Year Start: 2021 Model: Camry Prod Date Range: [10/2020 -           ]
Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION; 2021 - 2024 MY Camry [10/2020 -        ]

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

    Target Adjustment (Triangle Target):

    Click here 2021 - 2024 MY Camry [10/2020 -        ]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: TARGET ADJUSTMENT(TRIANGLE TARGET)

    Target Adjustment (Flat Surface Target):

    Click here 2021 - 2024 MY Camry [10/2020 -        ]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: TARGET ADJUSTMENT(FLAT SURFACE TARGET)

    Driving Adjustment:

    Click here 2021 - 2024 MY Camry [10/2020 -        ]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: DRIVING ADJUSTMENT

  • When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.

    Click here 2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: PARKING SUPPORT BRAKE SYSTEM: CALIBRATION

PROCEDURE

1. INSTALL FRONT BUMPER ASSEMBLY

(a) Move the front bumper assembly into position and engage the 2 guides and 2 claws as shown in the illustration.

Install in this Direction

(b) Install the 4 bolts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

(c) Install the 2 clips.

(d) w/ Parking Support Brake System:

(1) Connect the connector.

(e) w/ Pre-collision System:

(1) Connect the connector.

(f) Engage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.

Install in this Direction

(g) Install the 8 screws.

(h) Install the clip.

HINT:

Use the same procedure for the RH side and LH side.

(i) Engage the 4 claws to install the 2 pin hold clips as shown in the illustration.

Install in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(j) Install the front bumper assembly.

2. INSTALL COOL AIR INTAKE DUCT SEAL

(a) Engage the guide as shown in the illustration.

Install in this Direction (1)

Install in this Direction (2)

(b) Install the cool air intake duct seal with the 5 clips.

3. PERFORM CALIBRATION (w/ Panoramic View Monitor System)

Click here 2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

4. ADJUST HEADLIGHT AIMING

HINT:

Perform this procedure only when replacement of the front bumper reinforcement is necessary.

Click here 2018 - 2024 MY Camry [03/2017 -        ]; LIGHTING (EXT): HEADLIGHT ASSEMBLY: ADJUSTMENT