- Dynamic Radar Cruise Control System
- Lane Tracing Assist System
- Road Sign Assist System
- Front Radar Sensor System
- Pre-collision System
- Lighting System (EXT)
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001SAO1 |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Millimeter wave radar sensor assembly |
Adjust millimeter wave radar sensor assembly |
|
Target Adjustment (Triangle Target):
or Target Adjustment (Flat Surface Target):
or Driving Adjustment:
|
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
![2021 - 2024 MY Camry [10/2020 - ]; EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
|
(a) Disconnect the connector. |
|
(b) Remove the 2 bolts and screw.
|
Bolt |
|
Screw |
(c) Disengage the 2 guides and remove the millimeter wave radar sensor assembly.
NOTICE:
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.
|
|