| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001RMUO |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION ECU: INSTALLATION; 2021 - 2024 MY Camry [10/2020 - ] | ||
INSTALLATION
PROCEDURE
1. PRECAUTION
NOTICE:
-
When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly or navigation ECU may not operate normally.
- After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.
2. INSTALL NAVIGATION ECU
3. INSTALL DCM (TELEMATICS TRANSCEIVER) (w/ Manual (SOS) Switch)
4. INSTALL NO. 1 TELEPHONE BRACKET
(a) w/o Manual (SOS) Switch:
(1) Install the No. 1 telephone bracket with the 2 screws.
(b) w/ Manual (SOS) Switch:
(1) Install the No. 1 telephone bracket with the 3 screws.
5. INSTALL NO. 2 TELEPHONE BRACKET
(a) w/o Manual (SOS) Switch:
(1) Install the No. 2 telephone bracket with the 2 screws.
(b) w/ Manual (SOS) Switch:
(1) Install the No. 2 telephone bracket with the 3 screws.
6. INSTALL ANTENNA CORD SUB-ASSEMBLY
(a) w/o Manual (SOS) Switch:
(1) Engage the clamp to install the antenna cord sub-assembly.
(2) Connect the connector.
(b) w/ Manual (SOS) Switch:
(1) Engage the clamp to install the antenna cord sub-assembly.
(2) Connect the 4 connectors.
7. INSTALL NAVIGATION ECU WITH BRACKET
(a) Connect each connector.
(b) Engage the clamp.
(c) Engage the 3 guides.
(d) Install the navigation ECU with bracket with the 3 bolts.
(e) Connect each connector.
8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Click here
![2020 - 2024 MY Camry [03/2020 - ]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
for UB80E:
Click here
for UA80E:
Click here
for UB80F:
Click here
10. INSTALL SHIFT LOCK RELEASE BUTTON COVER
for UB80E:
Click here
for UA80E:
Click here
for UB80F:
Click here
11. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Click here
12. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH
Click here
13. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here
14. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 7 Inch Display)
Click here
15. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 9 Inch Display)
Click here
16. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
Click here
|
|