| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001RLRX |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: AUDIO / VIDEO: RADIO ANTENNA CORD: REMOVAL; 2021 - 2024 MY Camry [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedures |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision System |
|||
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
|
Panoramic View Monitor System |
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
![2021 - 2022 MY Camry [10/2020 - 08/2022]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
2. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
Click here
3. REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Click here
4. REMOVE ANTENNA CORD SUB-ASSEMBLY
(a) w/o Navigation Antenna:
(1) Disengage the 5 clamps and remove the antenna cord sub-assembly.
(b) w/ Navigation Antenna:
(1) Disconnect the connector.
(2) Disengage the 2 claws.
(3) Disengage the 7 clamps and remove the antenna cord sub-assembly.
5. REMOVE ROOF HEADLINING ASSEMBLY
Click here
6. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
(a) Remove the adhesive tape from the roof headlining assembly.
for Normal Roof:
|
Adhesive Tape |
- |
- |
for Moon Roof:
|
|
Adhesive Tape |
- |
- |
for Panoramic Moon Roof:
|
|
Adhesive Tape |
- |
- |
(b) Remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.
7. REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Manual (SOS) Switch)
|
(a) Disconnect the connector. |
|
(b) Disengage the 5 clamps to remove the No. 5 antenna cord sub-assembly.
|
|