| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001RE8J |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: U1000; CAN Communication Failure (Message Registry); 2021 - 2024 MY Camry [10/2020 - ] | ||
|
DTC |
U1000 |
CAN Communication Failure (Message Registry) |
DESCRIPTION
If DTC U1000 is stored frequently, duplicate the problem symptoms and perform troubleshooting again even if the DTC is not output when rechecking for DTCs.
Television Camera Controller
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
U1000 |
CAN Communication Failure (Message Registry) |
ECU malfunction |
Television camera controller |
Circumference Monitoring Camera Control Module |
Rear Television Camera Assembly
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
U1000 |
CAN Communication Failure (Message Registry) |
ECU malfunction |
Rear television camera assembly |
Parking Assist Camera |
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
Chassis > Parking Assist Camera > Clear DTCs
(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
Chassis > Parking Assist Camera > Trouble Codes
HINT:
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even if the DTC was not output when rechecking for DTCs.
Click here
![2021 - 2024 MY Camry [10/2020 - ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: PROBLEM SYMPTOMS TABLE](/t3Portal/stylegraphics/info.gif)
|
Result |
Proceed to |
|---|---|
|
No DTCs are output |
A |
|
DTC U1000 is output ("Panoramic View Monitor") |
B |
|
DTC U1000 is output ("Parking Assist Camera") |
C |
| A |
|
USE SIMULATION METHOD TO CHECK
|
| B |
|
| C |
|
|
|