PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1697; Camera Position Adjustment Incomplete; 2021 - 2024 MY Camry [10/2020

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM100000001RE8E
Model Year Start: 2021	Model: Camry	Prod Date Range: [10/2020 - ]
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1697; Camera Position Adjustment Incomplete; 2021 - 2024 MY Camry [10/2020 - ]

DTC

C1697

Camera Position Adjustment Incomplete

DESCRIPTION

This DTC is stored when the television camera controller judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1697	Camera Position Adjustment Incomplete	Camera initial setting has not been memorized	Camera view adjustment Television camera controller

CAUTION / NOTICE / HINT

NOTICE:

When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here

PROCEDURE

1.	ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT)

(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the television camera controller.

(1) Refer to camera view adjustment.

Click here

2.	CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C1697 is not output.

HINT:

If DTC C1697 is output, perform the camera view adjustment again.
If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the television camera controller.

END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE)

REPLACE TELEVISION CAMERA CONTROLLER