| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001RE8D |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1694; Steering Angle Initialization Incomplete; 2021 - 2024 MY Camry [10/2020 - ] | ||
|
DTC |
C1694 |
Steering Angle Initialization Incomplete |
DESCRIPTION
This DTC is stored when the television camera controller and rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
Television Camera Controller
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C1694 |
Steering Angle Initialization Incomplete |
Maximum steering angle has not been memorized |
|
Circumference Monitoring Camera Control Module |
Rear Television Camera Assembly
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C1694 |
Steering Angle Initialization Incomplete |
Maximum steering angle has not been memorized |
|
Parking Assist Camera |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
![2021 - 2024 MY Camry [10/2020 - ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
|
1. |
PERFORM SETTINGS (STEERING ANGLE SETTING) |
(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the television camera controller.
(1) Refer to steering angle setting.
Click here
|
|
2. |
CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
Chassis > Parking Assist Camera > Clear DTCs
(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
Chassis > Parking Assist Camera > Trouble Codes
HINT:
- If DTC C1694 is output, perform the steering angle setting again.
- If DTC C1694 is still output after performing the steering angle setting 3 times, replace the television camera controller.
|
Result |
Proceed to |
|---|---|
|
No DTCs are output |
A |
|
DTC C1694 is output ("Panoramic View Monitor") |
B |
|
DTC C1694 is output ("Parking Assist Camera") |
C |
| A |
|
END (SETTINGS ARE DEFECTIVE) |
| B |
|
| C |
|
|
|