Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001RE8D
Model Year Start: 2021 Model: Camry Prod Date Range: [10/2020 -           ]
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1694; Steering Angle Initialization Incomplete; 2021 - 2024 MY Camry [10/2020 -        ]

DTC

C1694

Steering Angle Initialization Incomplete

DESCRIPTION

This DTC is stored when the television camera controller and rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

Television Camera Controller

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

DTC Output from

C1694

Steering Angle Initialization Incomplete

Maximum steering angle has not been memorized

  • Steering angle setting
  • Television camera controller

Circumference Monitoring Camera Control Module

Rear Television Camera Assembly

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

DTC Output from

C1694

Steering Angle Initialization Incomplete

Maximum steering angle has not been memorized

  • Steering angle setting
  • Rear television camera assembly

Parking Assist Camera

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here 2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here 2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

PROCEDURE

1.

PERFORM SETTINGS (STEERING ANGLE SETTING)

(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the television camera controller.

(1) Refer to steering angle setting.

Click here 2021 - 2024 MY Camry [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

NEXT

2.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

Chassis > Parking Assist Camera > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

Chassis > Parking Assist Camera > Trouble Codes

HINT:

  • If DTC C1694 is output, perform the steering angle setting again.
  • If DTC C1694 is still output after performing the steering angle setting 3 times, replace the television camera controller.

Result

Proceed to

No DTCs are output

A

DTC C1694 is output ("Panoramic View Monitor")

B

DTC C1694 is output ("Parking Assist Camera")

C

A

END (SETTINGS ARE DEFECTIVE)

B

REPLACE TELEVISION CAMERA CONTROLLER

C

REPLACE REAR TELEVISION CAMERA ASSEMBLY