| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001RE83 |
| Model Year Start: 2021 | Model: Camry | Prod Date Range: [10/2020 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1625; Open or Short in Steering Angle Sensor +B; 2021 - 2024 MY Camry [10/2020 - ] | ||
|
DTC |
C1625 |
Open or Short in Steering Angle Sensor +B |
DESCRIPTION
This DTC is stored if the television camera controller and rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.
Television Camera Controller
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C1625 |
Open or Short in Steering Angle Sensor +B |
Open or short in steering angle sensor +B |
|
Circumference Monitoring Camera Control Module |
Rear Television Camera Assembly
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C1625 |
Open or Short in Steering Angle Sensor +B |
Open or short in steering angle sensor +B |
|
Parking Assist Camera |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
- Since the panoramic view monitor system has functions that use the CAN communication system, first check that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
![2021 - 2024 MY Camry [10/2020 - ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
- Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE) |
(a) Disconnect the K71 steering sensor connector.
Click here
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
K71-6 (ESS) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
K71-9 (IG1) - K71-6 (ESS) |
Ignition switch ON |
11 to 14 V |
|
K71-4 (BAT) - K71-6 (ESS) |
Ignition switch off |
11 to 14 V |
| OK |
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|