SYSTEM DESCRIPTION

OPERATION EXPLANATION

(a) The reverse position signal is sent from the shift position switch to the television camera controller when the shift position is moved to R.

(b) An appropriate steering angle and timing information can be provided for the driver. This is based on the information from the steering angle sensor signal and the vehicle angle data signal that are sent to the television camera controller.

HINT:

The steering angle sensor signal is used to control parking assist only for estimated guide line mode.

COMMUNICATION SYSTEM OUTLINE

(a) CAN communication system

(1) The panoramic view monitor system uses CAN communication for data communications between the television camera controller and each ECU.

(2) If a problem occurs in the CAN communication line, the television camera controller outputs a CAN communication malfunction DTC. (To check, use the Techstream.)

Click here

(3) If a problem occurs in the CAN communication line, the television camera controller outputs a CAN communication malfunction DTC. (To check, use the radio and display receiver assembly diagnosis screen.)

Click here

(4) If a CAN communication line malfunction DTC is output, repair the malfunction in the communication line and troubleshoot the panoramic view monitor system when data communication is normal.

(5) Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.

VIDEO SIGNALS

(a) Video signal circuit

(1) Video signals from the front television camera assembly are input into the television camera controller via analog communication lines (vehicle wire harness).

(2) Video signals from the side television camera assembly LH are input into the television camera controller via analog communication lines (vehicle wire harness).

(3) Video signals from the side television camera assembly RH are input into the television camera controller via analog communication lines (vehicle wire harness).

(4) Video signals from the rear television camera assembly are input into the television camera controller via analog communication lines (vehicle wire harness).

(5) Video signals from the television camera controller are input into the radio and display receiver assembly via analog communication lines (vehicle wire harness).

(b) Screen display

(1) Video signals input from each camera are processed in the television camera controller and displayed on the radio and display receiver assembly as the panoramic view monitor system screen.

DIAGNOSTIC FUNCTION OUTLINE

(a) This panoramic view monitor system has a diagnostic function displayed in the radio and display receiver assembly. This function enables the calibration (adjustment and verification) of the panoramic view monitor system.

Click here

(b) The panoramic view monitor system can check the following items by using the Techstream.

CALIBRATION

(a) Use the panoramic view monitor system diagnosis screen for calibration and checking of the panoramic view monitor system.

Click here

NOTICE:

Part replacement and work performed during servicing may require calibration of the panoramic view monitor system and other systems.

Click here