HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System): PROBLEM SYMPTOMS TABLE; 2021 - 2024 MY Camry [10/2020

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM100000001R3Z0
Model Year Start: 2021	Model: Camry	Prod Date Range: [10/2020 - ]
Title: HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System): PROBLEM SYMPTOMS TABLE; 2021 - 2024 MY Camry [10/2020 - ]

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

VEHICLE CHECK ITEMS

HINT:

You can reduce the number of systems to check by using the results of the following operation check
Perform the following checks based on Customer Feedback and the vehicle condition.
The customer's opinion may not be consistent with the actual problem (eg: the cooling performance of the air conditioner is bad → actually, the wind volume is weak). It is important to check the problem symptoms accurately and judge correctly based on various sources of information.
Judgment as to whether the air conditioner panel is normal or abnormal can be judged by checking if the indicator illuminates or turns off when the switch is operated.
During servo motor initialization, the AUTO indicator light comes on, and then goes off when initialization has finished.
If the performance of the air conditioner is poor or there is a foul odor, check for clogging in the clean air filter.

Malfunction Operation/Function:

Common Function of Cool and Heater Function				Only Cool Air Function	Only Heater Function	Suspected Area
A/C Switch Operation	Blower Operation	Recirculation/Fresh Function	Air Outlet Changing Function	Only Cool Air Function	Only Heater Function	Suspected Area
x	o	o	o	x	x	Go to "Problem Symptoms Table: Air Conditioning Control"
o	o	o	o	x	o	Go to "Problem Symptoms Table: Cooling Function"
o	o	o	o	o	x	Go to "Problem Symptoms Table: Heater Function"
o	x	o	o	x	x	Go to "Problem Symptoms Table: Blower Control"
o	o	x	o	x	x	Go to "Problem Symptoms Table: Air Inlet Control"
o	o	o	x	x	x	Go to "Problem Symptoms Table: Air Outlet Control"
x	x	x	x	x	x	Air Conditioning Amplifier Assembly or Air Conditioning Assembly is Defective

AIR CONDITIONING CONTROL

Symptom	Suspected Area	Link
Air conditioning system cannot be operated using air conditioning control assembly (With the exception of the switch indicators, no inputs are reflected when other switches operated)	Air conditioning amplifier assembly Blower motor with fan sub-assembly Air conditioning control assembly
Air conditioning system cannot be operated using air conditioning control assembly	Air conditioning control assembly
Air conditioning system cannot be operated using air conditioning control assembly immediately after starting the engine (Air conditioning system display operates) (Only AUTO indicator illuminates) (A/C switch indicator does not illuminate)	Refer to "INITIALIZATION"
A/C switch indicator does not illuminate	Air conditioning amplifier assembly Air conditioning control assembly Servo motor initialization (incomplete) Mechanical locking of damper and damper link Low detected ambient temperature (including thermistor assembly malfunction)

COOLING FUNCTION

Symptom	Suspected Area	Link
No cool air comes out (Blower control is normal)	Compressor assembly with pulley (compressor solenoid)1 Cooler compressor assembly (compressor solenoid)2 Refrigerant pressure is extremely high or low Refrigerant volume (low) Clogged cooler condenser assembly fins Cooling fan system malfunction Mechanical locking of damper and damper link No. 1 cooler thermistor High inlet air temperature
Cooling effectiveness is poor Cooling response is slow	Compressor assembly with pulley (compressor solenoid)1 Cooler compressor assembly (compressor solenoid)2 Refrigerant volume (high) Refrigerant volume (low) Clogged cooler condenser assembly fins Cooling fan system malfunction Mechanical locking of damper and damper link Automatic light control sensor High inlet air temperature
Temperature of outlet air is cooler on left or right side (when same temperature set for both sides)*3	Compressor assembly with pulley (compressor solenoid)1 Cooler compressor assembly (compressor solenoid)2 Refrigerant volume (low) Mechanical locking of damper and damper link Automatic light control sensor High inlet air temperature
Compressor assembly with pulley does not stop operating2 Refrigerant pressure does not decrease when A/C switch is turned off2	Short to +B in air conditioning amplifier assembly circuit Magnetic clutch relay Magnet clutch assembly

*1: for A25A-FKS
*2: for 2GR-FKS
*3: for Dual Type

HEATER FUNCTION

Symptom	Suspected Area	Link
No warm air comes out (Blower control is normal) Outlet air temperature does not increase (Blower control is normal)	Engine coolant temperature (low) Refrigerant volume (low) No. 1 air conditioning radiator damper servo sub-assembly Warm-up control Blockage in heater radiator unit sub-assembly Flow shutting valve (water by-pass hose assembly)*1
Temperature of outlet air is warmer on left or right side (when same temperature set for both sides)*2	Mechanical locking of damper and damper link Blockage in heater radiator unit sub-assembly

*1: for A25A-FKS
*2: for Dual Type

BLOWER CONTROL

Symptom	Suspected Area	Link
Blower motor does not operate at all (Air does not blow from registers)	Blower motor with fan sub-assembly (power source and ground circuits) Communication malfunction between air conditioning amplifier assembly and blower motor with fan sub-assembly Blower motor with fan sub-assembly Air conditioning amplifier assembly Warm-up control Engine coolant temperature sensor
Airflow volume cannot be changed	Air conditioning amplifier assembly Blower motor with fan sub-assembly Air conditioning control assembly Clogged No. 1 evaporator sub-assembly or heater radiator unit sub-assembly fins Clogged clean air filter
Airflow volume is constantly low Airflow volume sometimes becomes low	Communication malfunction between air conditioning amplifier assembly and blower motor with fan sub-assembly Blower motor with fan sub-assembly Air conditioning amplifier assembly Clogged No. 1 evaporator sub-assembly or heater radiator unit sub-assembly fins Clogged clean air filter Aspirator installation condition

AIR INLET CONTROL

Symptom	Suspected Area	Link
Air inlet mode changes between recirculation/fresh randomly Recirculation/fresh switch indicator is blinking	Change in ambient air temperature Decrease in refrigerant pressure Air conditioner pressure sensor circuit Engine coolant temperature (high)
Air inlet mode cannot be changed between recirculation/fresh Air inlet mode does not change between recirculation/fresh automatically Exhaust gas odors can be smelled when air inlet mode set to recirculation mode	No. 1 blower damper servo sub-assembly Damper link disconnection Air inlet damper mechanically locked Engine coolant temperature (high) Air conditioner unit assembly

AIR OUTLET CONTROL

Symptom	Suspected Area	Link
Air outlet mode cannot be changed (air outlet display changes)	No. 1 air conditioning radiator damper servo sub-assembly (mode) Damper link disconnection Air conditioner unit assembly
Air outlet mode cannot be changed (air outlet display does not change)	Air conditioning control assembly

DEFROSTER CONTROL

Symptom	Suspected Area	Link
Windshield frequently fogs up (cooling is insufficient)	Compressor assembly with pulley (compressor solenoid)1 Cooler compressor assembly (compressor solenoid)2 Refrigerant volume (low) Cooler expansion valve (opened excessively) No. 1 air conditioning radiator damper servo sub-assembly (mode) Mechanical locking of damper and damper link

*1: for A25A-FKS
*2: for 2GR-FKS