Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001MOTJ
Model Year Start: 2020 Model: Camry Prod Date Range: [03/2020 -           ]
Title: AXLE AND DIFFERENTIAL: REAR AXLE HUB (for AWD): ON-VEHICLE INSPECTION; 2020 - 2024 MY Camry [03/2020 -        ]

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here 2018 - 2024 MY Camry [06/2017 -        ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL+

2. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Click here 2018 - 2024 MY Camry [06/2017 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE ACTUATOR: REMOVAL+

3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Click here 2018 - 2024 MY Camry [06/2017 -        ]; AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT(w/ Electric Parking Brake System): REPLACEMENT+

4. REMOVE REAR DISC

Click here 2018 - 2024 MY Camry [06/2017 -        ]; BRAKE (REAR): REAR BRAKE (w/ Electric Parking Brake System): REMOVAL+

5. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator with magnetic base, check for looseness near the center of the rear axle hub.

Maximum Looseness:

0.05 mm (0.00196 in.)

NOTICE:

  • Ensure that the dial indicator is set perpendicular to the measurement surface.
  • Keep the magnet of the dial indicator away from the rear skid control sensor.

HINT:

If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.

6. INSPECT REAR AXLE HUB RUNOUT

(a) Using a dial indicator with magnetic base, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.

Maximum Runout:

0.05 mm (0.00196 in.)

NOTICE:

  • Ensure that the dial indicator is set perpendicular to the measurement surface.
  • Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolts.
  • Keep the magnet of the dial indicator away from the rear skid control sensor.

HINT:

If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.

7. INSTALL REAR DISC

Click here 2018 - 2024 MY Camry [06/2017 -        ]; BRAKE (REAR): REAR BRAKE (w/ Electric Parking Brake System): INSTALLATION+

8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Click here 2018 - 2024 MY Camry [06/2017 -        ]; AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT(w/ Electric Parking Brake System): REPLACEMENT+

9. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Click here 2018 - 2024 MY Camry [06/2017 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE ACTUATOR: INSTALLATION+

10. INSTALL REAR WHEEL

Click here 2018 - 2024 MY Camry [06/2017 -        ]; MAINTENANCE: TIRE AND WHEEL: INSTALLATION+