Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001L8CV |
Model Year Start: 2020 |
Model: Camry |
Prod Date Range: [09/2019 -
] |
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter; 2020 - 2024 MY Camry [09/2019 - ] |
Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
|
DESCRIPTION
The stereo component amplifier assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function.
HINT:
-
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls its respective systems based on this pulse signal.
-
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the following diagram will not operate normally.
WIRING DIAGRAM
PROCEDURE
1.
|
INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM)
|
(a) Check the output waveform.
(1) Remove the combination meter assembly with the connector(s) still connected.
(2) Connect an oscilloscope to terminal K21-6 (+S) and body ground.
(3) Turn the ignition switch to ON.
(4) Turn a wheel slowly.
(5) Check the signal waveform according to the condition(s) in the table below.
Item
|
Condition
|
Measurement terminal
|
K21-6 (+S) - Body ground
|
Tool setting
|
5 V/DIV., 20 ms./DIV.
|
Vehicle condition
|
Wheel being rotated
|
OK:
The waveform is similar to that shown in the illustration.
HINT:
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
|
|
*a
|
Component with harness connected
(Combination Meter Assembly)
|
|
|
OK
|
|
|
2.
|
INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (INPUT WAVEFORM)
|
(a) Check the input waveform.
*a
|
Component with harness connected
(Stereo Component Amplifier Assembly)
|
-
|
-
|
(1) Remove the stereo component amplifier assembly with the connector(s) still connected.
(2) Connect an oscilloscope to terminal K10-11 (SPD) and body ground.
(3) Turn the ignition switch to ON.
(4) Turn a wheel slowly.
(5) Check the signal waveform according to the condition(s) in the table below.
Item
|
Condition
|
Measurement terminal
|
K10-11 (SPD) - Body ground
|
Tool setting
|
5 V/DIV., 20 ms./DIV.
|
Vehicle condition
|
Wheel being rotated
|
OK:
The waveform is similar to that shown in the illustration.
HINT:
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|