| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001JTPM |
| Model Year Start: 2020 | Model: Camry | Prod Date Range: [09/2019 - ] |
| Title: DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: REMOVAL; 2020 - 2024 MY Camry [09/2019 - ] | ||
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL LH
Click here
![2018 - 2024 MY Camry [06/2017 - ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
HINT:
Use the same procedure as for the RH side.
Click here
3. REMOVE FRONT FENDER LINER LH
HINT:
Use the same procedure as for the RH side.
Click here
4. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
5. REMOVE HOOD LOCK ASSEMBLY
|
(a) Disconnect the connector. |
|
|
(b) Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap. |
|
|
(c) Remove the 2 bolts and hood lock bolt. |
|
|
(d) Disconnect the hood lock control cable assembly to remove the hood lock assembly. |
|
6. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
9. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
|
(a) Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly. |
|
11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
|
(a) Disengage the clamp. |
|
(b) Using a screwdriver, disengage the 4 clamps and grommet as shown in the illustration.
|
*1 |
Hood Lock Control Cable Assembly |
- |
- |
|
*a |
Clamp |
*b |
Grommet |
HINT:
Tape the screwdriver tip before use.
(c) Pull the hood lock control cable assembly from the engine compartment to remove it.
|
|