| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001JTPH |
| Model Year Start: 2020 | Model: Camry | Prod Date Range: [09/2019 - ] |
| Title: DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION; 2020 - 2024 MY Camry [09/2019 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
(b) Engage the grommet.
(c) Engage the 4 clamps to install the hood lock control cable assembly.
(d) Engage the clamp.
2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
(a) Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
![2018 - 2020 MY Camry [06/2017 - 10/2020]; INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
6. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
7. INSTALL HOOD LOCK ASSEMBLY
(a) Apply MP grease to the sliding areas of the hood lock assembly.
(b) Connect the hood lock control cable assembly to the hood lock assembly.
(c) Install the hood lock assembly with the 2 bolts and hood lock bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
HINT:
The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.
(d) Connect the connector.
8. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
9. INSTALL FRONT FENDER LINER LH
HINT:
Use the same procedure as for the RH side.
Click here
10. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
HINT:
Use the same procedure as for the RH side.
Click here
11. INSTALL FRONT WHEEL LH
Click here
12. ADJUST HOOD SUB-ASSEMBLY
Click here
|
|