- Steering angle neutral point (Initialize parking assist monitor system)
- Steering angle setting
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM10000000160TL |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - 10/2020] |
| Title: LIGHTING (EXT): SWITCH HOUSING: REMOVAL; 2018 - 2020 MY Camry [06/2017 - 10/2020] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel switch housing removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
*1: w/ Parking Assist Monitor System
*2: w/ Panoramic View Monitor System *3: w/ Intelligent Clearance Sonar System *4: When performing learning using the Techstream. Click here
|
|||
|
Removal/installation of the spiral cable with sensor sub-assembly*1 |
|
Parking assist monitor system |
|
|
Removal/installation of the spiral cable with sensor sub-assembly*2 |
Steering angle neutral point (Initialize panoramic view monitor system) |
Panoramic view monitor system |
|
|
Removal/installation of the spiral cable with sensor sub-assembly*3 |
Steering angle neutral point (Initialize intelligent clearance sonar system) |
|
|
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
|
Pre-collision system |
|||
|
Intelligent clearance sonar system*4 |
|||
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
|
Panoramic view monitor system |
|
||
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
![2018 - 2019 MY Camry [06/2017 - 09/2019]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here
2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Click here
3. REMOVE TURN SIGNAL SWITCH
Click here
4. REMOVE STEERING WHEEL SWITCH HOUSING
|
(a) Using pliers, expand the clamp as shown in the illustration. |
|
(b) While holding the clamp expanded, using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the steering wheel switch housing as shown in the illustration.
|
*a |
Protective Tape |
|
Remove in this Direction |
|
|