Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000015WD1 |
Model Year Start: 2018 |
Model: Camry |
Prod Date Range: [06/2017 -
] |
Title: HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System): Recirculated/Fresh Air Modes do not Switch; 2018 - 2024 MY Camry [06/2017 - ] |
Recirculated/Fresh Air Modes do not Switch
|
DESCRIPTION
If the air inlet mode cannot be changed between recirculation/fresh or exhaust gas odors can be smelled even though recirculation mode is selected, the following suspected areas may be the cause.
Symptom
|
Factor
|
-
Air inlet mode cannot be changed between recirculation/fresh
-
Exhaust gas odors can be smelled when air inlet mode set to recirculation mode
|
-
No. 1 blower damper servo sub-assembly malfunction
-
Damper link disconnection
-
Air inlet damper mechanically locked
-
Engine coolant temperature (high)
|
PROCEDURE
1.
|
CHECK NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY
|
(a) Check that the No. 1 blower damper servo sub-assembly is installed correctly.
OK:
The No. 1 blower damper servo sub-assembly is installed correctly.
OK
|
|
|
(a) Check for DTCs.
Body Electrical > Air Conditioner > Trouble Codes
OK:
DTC B1442 is not output
OK
|
|
|
3.
|
READ VALUE USING TECHSTREAM
|
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Data List.
(e) Read the Data List according to the display on the Techstream.
Powertrain > Engine > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
Coolant Temperature
|
Engine coolant temperature
|
Min.: -40°C (-40°F), Max.: 140°C (284°F)
|
75 to 100°C (167 to 212°F): After warming up
|
This is the engine coolant temperature.
HINT:
-
After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).
-
After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.
-
If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
-
Check if the engine overheats if the value indicated is higher than 135°C (275°F).
|
Powertrain > Engine > Data List
Tester Display
|
Coolant Temperature
|
OK:
After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.
NG |
|
GO TO COOLING SYSTEM
for A25A-FKS: Click here
for 2GR-FKS: Click here
|
|