| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000015QKH |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - ] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION; 2018 - 2024 MY Camry [06/2017 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL HORN BUTTON ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) When using a new spiral cable sub-assembly:
(1) Engage the wire harness clamp and disconnect the airbag connector as shown in the illustration.
|
*a |
Wire Harness Clamp |
|
*b |
Airbag Connector |
|
Remove in this Direction |
HINT:
Be sure to engage the wire harness clamp until it is locked.
(d) When reusing a spiral cable sub-assembly or spiral cable with sensor sub-assembly:
|
*a |
Airbag Connector |
|
*b |
Horn Connector |
|
*c |
Airbag Connector Locking Button |
|
*d |
Wire Harness Clamp |
|
|
Push in this Direction |
(1) Engage the wire harness clamp.
(e) Connect the 2 airbag connectors to the horn button assembly.
NOTICE:
- When connecting any airbag connector, take care not to damage the airbag wire harness.
- Be sure to connect the connectors to each corresponding color.
(f) Push in the 2 airbag connector locking buttons to install the 2 airbag connectors.
(g) Connect the horn connector to the horn button assembly.
|
(h) Push the horn button assembly to engage the 3 pins carefully and install the horn button assembly. NOTICE:
|
|
2. INSTALL LOWER NO. 2 STEERING WHEEL COVER (w/ Cover)
(a) Engage each claw to install the 3 lower No. 2 steering wheel covers.
|
*A |
for LH Side |
*B |
for RH Side |
|
*C |
for Under Side |
- |
- |
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for A25A-FKS: Click here
![2018 MY Camry [03/2017 - 08/2018]; MAINTENANCE: A25A-FKS BATTERY: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
for 2GR-FKS: Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
4. INSPECT HORN BUTTON ASSEMBLY
(a) Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
Click here
5. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
6. INSPECT SRS WARNING LIGHT
Click here
|
|