| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000015L2B |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - 10/2020] |
| Title: PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM: C1AF7; RCTB Sensor; 2018 - 2020 MY Camry [06/2017 - 10/2020] | ||
|
DTC |
C1AF7 |
RCTB Sensor |
DESCRIPTION
This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating a malfunction in the blind spot monitor sensor.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1AF7 |
RCTB Sensor |
Blind spot monitor sensor malfunction |
Blind spot monitor system |
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
HINT:
After turning the engine switch from off to on (IG), wait 4 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
(b) Clear the DTCs according to the screen on the Techstream.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs
(c) Recheck for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
HINT:
- DTC C1AF7 is stored when a malfunction signal sent from the blind spot monitor system is detected.
- If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AF7 will not be output again.
- If DTC C1AF7 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
|
Result |
Proceed to |
|---|---|
|
DTC C1AF7 is output |
A |
|
DTC C1AF7 is not output |
B |
| A |
|
| B |
|
USE SIMULATION METHOD TO CHECK
|
![2018 MY Camry [06/2017 - 08/2018]; INTRODUCTION: HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS: HOW TO PROCEED WITH TROUBLESHOOTING](/t3Portal/stylegraphics/info.gif)
|
|