Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000015KHU |
Model Year Start: 2018 |
Model: Camry |
Prod Date Range: [06/2017 - 09/2019] |
Title: MIRROR (EXT): OUTER REAR VIEW MIRROR: REMOVAL; 2018 - 2019 MY Camry [06/2017 - 09/2019] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during outer rear view mirror assembly with cover removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
-
Side television camera assembly LH
-
Outer rear view mirror assembly LH
-
Side television camera assembly RH
-
Outer rear view mirror assembly RH
|
Side television camera view adjustment
|
Panoramic view monitor system
|
|
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
Click here
2. REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY
Click here
3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
5. REMOVE FRONT ARMREST ASSEMBLY
Click here
6. REMOVE COURTESY LIGHT ASSEMBLY
Click here
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
8. REMOVE HOLE PLUG
(a) Remove the hole plug.
|
|
9. REMOVE OUTER MIRROR INSTALL HOLE COVER
(a) Disconnect the connector.
|
|
(b) Disengage the clamp.
(d) Disengage the clip and 2 claws to remove the outer mirror install hole cover.
10. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
(b) Remove the 3 nuts.
(c) Disengage the claw and 2 guides and remove the outer rear view mirror assembly with cover.
|