Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000015IK9
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 - 09/2019]
Title: 2GR-FKS (FUEL): FUEL PUMP ECU: REMOVAL; 2018 - 2019 MY Camry [06/2017 - 09/2019]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump control ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link
*: When performing learning using the Techstream.

Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM: CALIBRATION

Battery terminal is disconnected/reconnected

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

2018 - 2020 MY Camry [03/2017 - 10/2020]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision system

Intelligent clearance sonar system*

Memorize steering angle neutral point

Parking assist monitor system

2018 - 2024 MY Camry [03/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION

Panoramic view monitor system

2018 - 2020 MY Camry [06/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION

CAUTION:

  • Wear protective gloves. Sharp areas on the parts may injure your hands.
  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION

  • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  • If an airbag deploys for any reason, it may cause a serious injury.

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 2018 MY Camry [06/2017 - 08/2018]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2019 MY Camry [08/2018 - 09/2019]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION

3. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for TMC Made)

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

4. REMOVE REAR SEAT CUSHION ASSEMBLY

for TMC Made:

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

for TMMK Made:

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

5. REMOVE REAR SEAT CUSHION LOCK HOOK

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

6. REMOVE REAR SEATBACK ASSEMBLY LH

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.

10. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

11. REMOVE CENTER STOP LIGHT SET

Click here 2018 - 2024 MY Camry [03/2017 -        ]; LIGHTING (EXT): HIGH MOUNTED STOP LIGHT ASSEMBLY: REMOVAL+

12. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: REMOVAL+

13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

14. REMOVE INNER ROOF SIDE GARNISH LH

Click here 2018 MY Camry [06/2017 - 08/2018]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+ 2019 MY Camry [08/2018 - 09/2019]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

15. REMOVE INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.

16. REMOVE REAR SEAT SHOULDER BELT HOLE COVER

Click here 2018 - 2019 MY Camry [06/2017 - 09/2019]; SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: REMOVAL+

17. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; SEAT: REAR SEAT RECLINING CONTROL CABLE: REMOVAL+

18. REMOVE ROOM PARTITION BOARD LH

Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; SEAT: REAR SEAT RECLINING CONTROL CABLE: REMOVAL+

19. REMOVE FUEL PUMP CONTROL ECU

(a) Disconnect the 2 fuel pump control ECU connectors.

(b) Remove the nut and fuel pump control ECU from the vehicle body.

NOTICE:

Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.

20. REMOVE FUEL PUMP CONTROL ECU BRACKET

(a) Remove the 2 bolts and fuel pump control ECU bracket from the fuel pump control ECU.