| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM10000000158AL |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1691; Back Camera Initialization Incomplete; 2018 - 2024 MY Camry [06/2017 - ] | ||
|
DTC |
C1691 |
Back Camera Initialization Incomplete |
DESCRIPTION
This DTC is stored when the rear television camera assembly judges that the back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete).
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C1691 |
Back Camera Initialization Incomplete |
Back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete) |
|
Parking Assist Camera |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
![2018 - 2020 MY Camry [06/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
|
1. |
PERFORM SETTINGS (BACK CAMERA POSITION SETTING) |
(a) Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
(1) Rear television camera assembly optical axis adjustment (back camera position setting).
Click here
|
|
2. |
CHECK DTC OUTPUT |
(a) Clear the DTCs.
Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Parking Assist Camera > Trouble Codes
HINT:
- If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment (back camera position setting) again.
- If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the rear television camera assembly.
|
Result |
Proceed to |
|---|---|
|
DTC C1691 is output |
A |
|
DTC C1691 is not output |
B |
| A |
|
REPLACE REAR TELEVISION CAMERA ASSEMBLY
|
| B |
|
END |
|
|